If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
She makes a better Cheetah than the one that Mattel put out!
I am also jealous of the fact that you get to dress her up, while I have to wait three months to get a hold of mine.
You lucky, lucky man you.
Hmmm....I just had an idea.
Would it be possible to add additional sculpting to the head of the male figure when he comes out? I want to see if I can make a Vincent figure, from the Beauty and the Beast TV series.
I just need a pair of werewolf hands in the right scale, and making a fur wig can't be that hard.
Of course, I need the figure as well, but that can wait a bit.
Would it be possible to add additional sculpting to the head of the male figure when he comes out? I want to see if I can make a Vincent figure, from the Beauty and the Beast TV series.
I just need a pair of werewolf hands in the right scale, and making a fur wig can't be that hard.
Of course, I need the figure as well, but that can wait a bit.
If you're talking about adding additional sculpting to the head on my end that can't be done. It's already finished and altering it now would cost more money. The production pieces will be made out of PVC, not vinyl, so it might be possible to add other details to it with some type of sculpting material.
I should probably mention that I had to swap out the Yvonne feet with the Mattel feet so I could use the boots. The posts on the Mattel feet had to be modified so that they could be attached.
Good to know. Cheetah is the first figure of mine that will be getting the ZICA makeover. This female figure might make for a great "Princess" figure from Thundaar. FYI, I'm using the ZICA v.1 for Thundaar.
If a Mego figure of God did not exist, it would be necessary for EMCE to invent him.
Comment