If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi, I was wondering if there are any tricks for making the cowl line up to the eyes on the removable cowl Batman? The cowl always seems to be too high.
With mine, I wrapped some white material around Bruce Wayne's forehead, so when the cowl is in place it looks like Batman has white eyes like in the comic books. Not sure if there is a better way to make it actually line up.
[QUOTE=TheVintageToyKid;1453072]With mine, I wrapped some white material around Bruce Way'v forehead, so when the cowl is in place it looks like Batman has white eyes like in the comic books. Not sure if there is a better way to make it actually line up.[/QUOTE
Yep....went the unconventional route....Not using the old Bruce Wayne head...I never liked that head (for the cowl I'm using the Doc Mego rubber blue Cowl). I'm starting to post some of my customs again, have some new ones that I will be uploading soon. I'm looking to commission someone to paint my 1/9 scale Mego type heads...would you know of anyone who could paint?
I did the same thing (white eye lid) to my Lone Ranger's mask.....
I have not been able to figure out how to post pictures...but I just took scissors and trimmed off about an 1/8" from the bottom of the cowl. I need to clean up the edge but the eyes do line up.
Yep....went the unconventional route....Not using the old Bruce Wayne head...I never liked that head (for the cowl I'm using the Doc Mego rubber blue Cowl).
Well don't leave me in suspense... what head is under that cowl?
I will try to post a pic of my Bruce Wayne/cowl with white eyes as soon as possible. I am at work and don't have any photos of that particular figure on my phone.
"I thought they didn't allow no bathin' suits in here."
Comment