a talented guy over on the sideshow boards has this project on the go ,thought a few over here may be interested in them ,
above cards with placeholder figures
card backs
Here is the finished render of the Chris Reeve Superman figure. This will stand at 10.7cm (4.22 inches) tall when printed. The yellow emblem on the back of the cape will be added as a die-cut sticker. The original cape emblem was sewn on top of the red cape fabric, so there didn't seem to be any point sculpting the emblem into the cape model. I think the die-cut sticker will be a perfect representation of how it looked on the full size costume.
hes getting superman printed out before going forward with the proposed articulation
here a link to the full thread should any want more information or possible contact details
above cards with placeholder figures
card backs
Here is the finished render of the Chris Reeve Superman figure. This will stand at 10.7cm (4.22 inches) tall when printed. The yellow emblem on the back of the cape will be added as a die-cut sticker. The original cape emblem was sewn on top of the red cape fabric, so there didn't seem to be any point sculpting the emblem into the cape model. I think the die-cut sticker will be a perfect representation of how it looked on the full size costume.
hes getting superman printed out before going forward with the proposed articulation
here a link to the full thread should any want more information or possible contact details
Comment