AD&D Question...

[Rat King]

Mill Creek's version is with the original music etc. but no bonus features...

[mazinz]

Mill Creek's version is with the original music etc. but no bonus features...

but as with most of everything else Mills creek has ever released, does it have crap low budget transfers?

[Janson]

Mazinz thanks for the again man!

[Rat King]

but as with most of everything else Mills creek has ever released, does it have crap low budget transfers?

No the quality was pretty good

[mazinz]

No the quality was pretty good

thanks for the info on mills creek. If I did not already have the region 2 UK 20th centuiry Fox set (as well as the bci US set) I would prob pick up the Mills creek

[bizzaro megomauler]

if anyone actually gets the radio drama working please keep me in the loop.

[Rat King]

thanks for the info on mills creek. If I did not already have the region 2 UK 20th centuiry Fox set (as well as the bci US set) I would prob pick up the Mills creek

Hey for $8 it wasn't bad...I too would like to get the audio from that last episode....

[bizzaro megomauler]

Mazinz, that was awesome! you could close your eyes and picture how it would have looked easily. Thanks so much! I had read the script years ago,but it pales in comparison. I enjoyed it very much and appreciate you sharing!

[danadoll]

Maybe somebody will know here....

I was wondering if there are other 3 3/4 inch figure lines like the D&D figures by LJN, with the straight-arm/shoulder ball joints (or even a non-ball joint shoulder)) and straight leg (held by the rubber o-ring inside)?...Other than Gi Joe or the Micronauts, please...LOL!

I've been looking for other figures to use for D&D customs and my searches have found very little.

Any help would be appreciated, thanks folks.

Dana

[mazinz]

Maybe somebody will know here....

I was wondering if there are other 3 3/4 inch figure lines like the D&D figures by LJN, with the straight-arm/shoulder ball joints (or even a non-ball joint shoulder)) and straight leg (held by the rubber o-ring inside)?...Other than Gi Joe or the Micronauts, please...LOL!

I've been looking for other figures to use for D&D customs and my searches have found very little.

Any help would be appreciated, thanks folks.

Dana

hmm off hand the Dragonriders of the styx toy line had some characters that might help you
check the link below:
Dragonriders of the styx

[danadoll]

Thank you, Mazinz. I've seen them before, but I'll take another look at them.

Dana

[danadoll]

I had been considering GI Joe figures as a possible D&D customizing resource, but I've found that the GI Joe figures fall rather short of the stature of the AD&D figures by LJN. The Strongheart figure is actually about 4 1/4" (not including his helmet plume) and Mercion (one of the female figures) comes to 3 3/4 inches tall. Both Kelek and Ringlerun are about 3 3/4", but I've found (like Strongheart), almost all of the male warrior figures (Warduke, Bowmarc, etc...) measure around 4 1/4 inches.

I'm in a bit of a stall in finding compatible figures, I guess.

Dana

[Falstaff13]

Not sure how well they'd customize, but Empire's Legends of the West are 4" tall and might work. Course, then you'd be going after what I'm tracking down...