Hey everybody... question.... first the scenario...
On Friday, noticed an electrical burn smell in the main prod room.... smelled around, couldn't locate anything in particular and nothin was hot to the touch.
Fast Forward to 15 minutes ago...
The electrical burn smell intensified throughout the day today and then I look over and PC # 2 is off and won't come back on. The power button has it appearing to be in standby mode...
No doubt somethings went bad but what? Any suggestions on where to start. There is a lot of very specific hardware installed on the machine that is going to be a real witch to change out.
Any input is appreciated.
On Friday, noticed an electrical burn smell in the main prod room.... smelled around, couldn't locate anything in particular and nothin was hot to the touch.
Fast Forward to 15 minutes ago...
The electrical burn smell intensified throughout the day today and then I look over and PC # 2 is off and won't come back on. The power button has it appearing to be in standby mode...
No doubt somethings went bad but what? Any suggestions on where to start. There is a lot of very specific hardware installed on the machine that is going to be a real witch to change out.
Any input is appreciated.

Comment