If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
How much finish work are you having to do to get the pieces that smooth once they come off the printer? And if you are getting them to come out close to that clean, what printer do you use?
"If you take a dog which is starving and feed him and make him prosperous, that dog will not bite you. This is the primary difference between a dog and a man."
How much finish work are you having to do to get the pieces that smooth once they come off the printer? And if you are getting them to come out close to that clean, what printer do you use?
Once printed I put a glaze coat on the pieces to help smooth them out. A little sanding then prime and paint. ;-)
I hate to complain (being Canadian and all), but not sure where else to turn.
Back in early August 2016, I placed an order through Todd Mello's FanMade Props site to supplement my Batman '66 collection. Todd seemed to be a presence on the boards that was making pieces regularly for other members. This was what we agreed to:
Comment