Help needed on this custom

[Relic]

hulk.jpg I bought this busted up Hulk figure so that I can make a custom Solomon Grundy. None of the arms or legs were attached when I bought this. I put a small paper clip through each arm and leg and then ran a string through all the paper clips and up through the neck plug. Everything works fine and looks good when you pull up on the string. The only way I can currently think of to keep tension on the string is to drill 2 holes in Hulks back, run the string through both holes and tie the string off. If someone out there has a better idea, please let me know. Thanks in advance

[piecemaker]

You need to use elastic string and restring it like shown here:http://www.megomuseum.com/custom/restringing.shtml

If stringing like a type one don't work you can string like a type two using two pieces of elastic string and running it through each leg to the opposite arm and then tying off.