Question about Hydrospan

[MeerkatMego]

I've tried using Hyrdospan twice and both times after I remove it from water it shrinks back to it's original size. Is this normal? The first time I only left the piece in water for about 7 or 8 days, but the second time I left it in a full 14 days. Any ideas what I might be doing wrong?

[BlackKnight]

Thats what it does. You need to mold right after you enlarge your head, with in a few hours.

[megowgsh]

What I do is this:

Leave it in water until it is as big as it can get. Then take it out and let it shrink down to where you want it to be. Once it is the size you want, put it in an air-tight container (tupperware or similar) and leave it for a 2-3 days. Take it out and make sure all the facial features are proportionate to the original; dry it off as well as you can and then mold it.

Good Luck!

PS If you have any trouble you can always call Hydrospan and they will give you technical advice, too.

[MeerkatMego]

Thanks guys I really thought I was doing something wrong.