Tweet
Your WEEKEND ASSIGNMENT!!! if you chose.
How was that title. Kinda made you feel back in High School Huh?
Putting this out there before I go to work tonite (BOO) and Yunz start the Holiday weekend!!! (Yeah)
This is a chair solution I fell into and wanted to share. Dont worry its cheap and no great skills are required (Its from me remember!!!) The big thing is that a Dremmil tool helps on this. But I'm sure it can be done without.
Ok lets get into it. Found these at the Dollar Stores. The SCOOPS maybe harder to find (World of Value) but the shape is whats important. The mini Champagne glasses I found in alot of Dollar stores (Party suply).
Next I used the "Grinding Wheel" to remove the handle from the scoop and smooth it down. Then remove one end of the champagne glass or the other. Here I used the base. But using the cup end makes a taller seat. Leave as much of the stem as possible for your INSERT.
Next... I used a cone shaped grinding tip to burrow a slot for the stem. This is trial and err. Ya know? Grind alittle, try a fitting, Grind alittle more. Etc... If you do it right. You can get a fit that requires no glue!!! (Although dont feel bad if yunz gotta wip out the Superglue) The hole works best near the cup of the scoop as this is where the center of gravity seems to be.
Here is the final product. As is... its great for narrower female figures. For the male figures. A little removal of the side scoop walls is needed. I hope this gives some of yunz an idea. And you run with it.
SAFETY CONCERNS!!! (Gotta add these)
This is GRINDING PLASTIC your doing here. Fumes will be released. So work in a well ventilated area. Use EYE PROTECTION. Flying bits of molten plastic will occcur!!! Dont show up for Mego Meet with no seeing eyedog!
Putting this out there before I go to work tonite (BOO) and Yunz start the Holiday weekend!!! (Yeah)
This is a chair solution I fell into and wanted to share. Dont worry its cheap and no great skills are required (Its from me remember!!!) The big thing is that a Dremmil tool helps on this. But I'm sure it can be done without.
Ok lets get into it. Found these at the Dollar Stores. The SCOOPS maybe harder to find (World of Value) but the shape is whats important. The mini Champagne glasses I found in alot of Dollar stores (Party suply).
Next I used the "Grinding Wheel" to remove the handle from the scoop and smooth it down. Then remove one end of the champagne glass or the other. Here I used the base. But using the cup end makes a taller seat. Leave as much of the stem as possible for your INSERT.
Next... I used a cone shaped grinding tip to burrow a slot for the stem. This is trial and err. Ya know? Grind alittle, try a fitting, Grind alittle more. Etc... If you do it right. You can get a fit that requires no glue!!! (Although dont feel bad if yunz gotta wip out the Superglue) The hole works best near the cup of the scoop as this is where the center of gravity seems to be.
Here is the final product. As is... its great for narrower female figures. For the male figures. A little removal of the side scoop walls is needed. I hope this gives some of yunz an idea. And you run with it.
SAFETY CONCERNS!!! (Gotta add these)
This is GRINDING PLASTIC your doing here. Fumes will be released. So work in a well ventilated area. Use EYE PROTECTION. Flying bits of molten plastic will occcur!!! Dont show up for Mego Meet with no seeing eyedog!
Comment