Help support the Mego Museum
Help support the Mego Museum

Announcement

Collapse
No announcement yet.

Trying something a bit different for Eddore of Tront

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • scott metzger
    Persistent Member
    • Jul 9, 2007
    • 2088

    Trying something a bit different for Eddore of Tront

    Eddore is basically the answer to the question, "What if an amoeba was a Green Lantern?" Thus, he makes for a challenge as far as an action figure goes. I'm going to try something different here, making him Mego scale and posable, hopefully. I worked up this on Photoshop:
    eddore copy.jpg

    to print out out on the printable cotton material I have. I cut the two halves out, sew them together, fit a wire armature inside, and then stuff it using cotton balls (that'll make it look kinda lumpy from past experience). I could sculpt something from Apoxy Sculpt, but that would majorly limit any potential posability. Just have to make sure it's in proper scale with the Mego figures and hope it doesn't look goofy...
    Last edited by scott metzger; Feb 3, '23, 11:53 AM.
  • bobws
    Permanent Member
    • Feb 13, 2008
    • 3462

    #2
    Now that is Determination and compulsion for completeness. Remember there are over 3600 GL's out there, the odds you get them all done is very unlikely.
    But please prove me wrong.
    "Hang on Lady... We go for a RIDE!" - Shorty to Willie Scott.Best movie line from Indiana Jones & the Temple Of Doom

    Comment

    Working...
    😀
    🥰
    🤢
    😎
    😡
    👍
    👎