If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The Cowardly Lion. I'm trying to work directly on the head but find it difficult. It would be much easier to resculpt on a resin copy.
If you did get a shrink of it, they are not flexible at all. They get really rigid. Would it work if it was smaller? Way cheaper than making a mold and casting one.
The Cowardly Lion. I'm trying to work directly on the head but find it difficult. It would be much easier to resculpt on a resin copy.
Rche, I appreciate the printing offer but I'm not there yet.
I've had luck working directly on a vinyl head. Just pack the head full with air dry clay and let it harden first. You can use the same air dry clay to make alterations on the resulting (non-squishy) head.
Comment