Any tips/tricks for drilling into vinyl?
I'm making a custom electronic Atomic Man and need to drill a 1/16th-inch hole in the head for the eye-bulb.
Normally I'd buy a small bit and use my dremel on low, is this the best approach?
I know the vinyl is fairly soft and I have to be careful not to melt it.
I'm making a custom electronic Atomic Man and need to drill a 1/16th-inch hole in the head for the eye-bulb.
Normally I'd buy a small bit and use my dremel on low, is this the best approach?
I know the vinyl is fairly soft and I have to be careful not to melt it.
Comment