Tweet
3D design by The Boy (aka Legend of Link).
My Godzilla head was disassembled and the broken gear was meticulously created with subtle differences to distinguish from the original.
Lever is 3D printed in Red and comes unpainted.
For every ten Godzillas on eBay, eight have this lever broken off. It was notorious to break on Gen1 and Gen2 models. Mattel redesigned the lever on Gen3 models due to high customer complaints.
Lever is $16.95 shipped in the continental USA.
Paypal is preferred, PM me your PayPal address and I will send an invoice.
If you desire me to install the new lever, I can for additional cost.
The lever:
FullSizeRender-8.jpg
The flame mechanism with the new lever attached:
FullSizeRender-3.jpg
The flame mechanism with a prototype grey lever:
FullSizeRender-7.jpg
The fully assembled head with new lever installed:
FullSizeRender-4.jpgFullSizeRender-6.jpg
My Godzilla head was disassembled and the broken gear was meticulously created with subtle differences to distinguish from the original.
Lever is 3D printed in Red and comes unpainted.
For every ten Godzillas on eBay, eight have this lever broken off. It was notorious to break on Gen1 and Gen2 models. Mattel redesigned the lever on Gen3 models due to high customer complaints.
Lever is $16.95 shipped in the continental USA.
Paypal is preferred, PM me your PayPal address and I will send an invoice.
If you desire me to install the new lever, I can for additional cost.
The lever:
FullSizeRender-8.jpg
The flame mechanism with the new lever attached:
FullSizeRender-3.jpg
The flame mechanism with a prototype grey lever:
FullSizeRender-7.jpg
The fully assembled head with new lever installed:
FullSizeRender-4.jpgFullSizeRender-6.jpg