If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
Did anyone order and receive yet their Suckadelic figure?
The tooling for the heads is being remade because the factory neglected to factor in the correct shrink rate. We could have gone with the smaller heads but that's not our style, it has to be right.
I received a sample of the jumpsuit today that will be used on both the AJ figures and the Sucklord figures. The factory did an outstanding job on it and the sample has been approved. Production will start on those as soon as possible and once we have them in stock we'll be able to sell the extra inventory that hasn't been allocated for the AJ and Sucklord figures.
It's unfortunate that the issue with the heads has caused this delay but it needed to be fixed.
Good to know, Craig - thanks for the update! Also, kudos on you guys for the quality control re: the heads, especially the AJ one, since that's the core for your entire AJ line. Gotta get that one 100%!
"It's sad that governments are chiefed by the double tongues. There is iron in your words of death for all Comanche to see, and so there is iron in your words of life. No signed paper can hold the iron. It must come from men. The words of Ten Bears carries the same iron of life and death. It is good that warriors such as we meet in the struggle of life... or death. It shall be life."
The tooling for the heads is being remade because the factory neglected to factor in the correct shrink rate. We could have gone with the smaller heads but that's not our style, it has to be right.
I received a sample of the jumpsuit today that will be used on both the AJ figures and the Sucklord figures. The factory did an outstanding job on it and the sample has been approved. Production will start on those as soon as possible and once we have them in stock we'll be able to sell the extra inventory that hasn't been allocated for the AJ and Sucklord figures.
It's unfortunate that the issue with the heads has caused this delay but it needed to be fixed.
The tooling for the heads is being remade because the factory neglected to factor in the correct shrink rate. We could have gone with the smaller heads but that's not our style, it has to be right.
It's unfortunate that the issue with the heads has caused this delay but it needed to be fixed.
Craig
That's good to hear Craig!Some companies will settle for factory errors such as "oversized" or "undersized" heads...and release them anyway. Then just say sorry, "it wasn't our fault."
Still waiting on that suckadelic figure I paid for. I actually forgot all about it. I suppose some kickstarter projects sometimes never come to fruition...did anyone get one? I think it was only $40 or such so no big loss, just wonderin...
Comment