If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Am I right to assume there is no clamshell model for kresge-type cards? Do people just glue blisters to the card? Anyway to make them openable like clamshells?
I'm about to glue a bubble down on my repo Kresge. But to have access to the figure you can make a slit on each side of the bottom
and don't glue the very bottom of the bubble down and then you have a flap that can release the figure.
If you need to secure it, just wrap some clear tape around the 3 sides at the bottom.
I'm gonna use a bubble i took of a Retro figure card which has a little flap in the back that i can just put a little tape on to hold it in place.
"Hang on Lady... We go for a RIDE!" - Shorty to Willie Scott.Best movie line from Indiana Jones & the Temple Of Doom
Comment